HP G7/Gen8 Blades: New Emulex firmware 4.2.401.2215 released
HP has released a new firmware version 4.2.401.2215 of its Emulex OneConnect 10Gb Ethernet Controller which is used in HP G7 and Gen8 Blades.
The built in LOM adapter names on a G7 Blade server are NC553i or NC551i and the Mezz card is NC554m. The CNA LOM added to a Gen8 Blade server is HP554FLB.
This firmware is required if you are going to be using the new dual hop FCoE features in Virtual Connect 4.01.
The firmware update process is offline and requires you to boot from an Emulex OneConnect bootable .ISO which can be downloaded from:
http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=329290&prodSeriesId=5033632&prodNameId=5033634&swEnvOID=54&swLang=8&mode=2&taskId=135&swItem=co-117280-1
The following issues have been resolved from the previous firmware version 4.2.401.605
- Fixed VMware PSOD ESX 4.1/5.0/5.1 seen on BL465cG7, BL685cg7 servers with BE2 based card. For more details see the following Customer Advisory
- Fixed FW memory leak with multiple logins to a redirected target
- Fixed FW to allow setting Speed/Duplex to Auto/Auto
- Fixed Fw to allow Bonding with Citrix platforms
- Fixed FW to allow upgrades of version 4.x to 4.x+ without requiring cold boot
- Fixed UEFI to not require 2nd reset
- Fixed UEFI driver version reported
- Fixed FW to prevent LOMS at 10G from negotiating 1G with Blade switches
- Fixed FW for BE3 to report correct values of ethernet stat “In Range” error
- Fixed FW to boot from secondary iSCSI when selected
- Fixed FW iSCSI boot failure from secondary target when primary target given is incorrect
- Fixed UEFI NIC default settings retention
- Fixed FW hang during boot with SLES 10 SP4
- Fixed FW error while performing Shared Uplink Set port remove/add test
I’ve updated my post: HP Virtual Connect Flex-10 & VMware ESX(i) pre-requisites
Recent Comments